604 Eos Apex, Eos Ti, Gio, Gio @5, Ion Xe, Ion Xe 20, and Element 2 User Manual
Program Change Events
Program Change commands typically represent a change in the MIDI voice or instrument type
that should be used for a particular MIDI channel. Similar to MIDI Note commands, the MIDI
data that is expected to be received is shown in the CIA and changes as you select event
parameters. When finished configuring the program change event, press {OK} to store the
event. Otherwise, press {Cancel} to undo the changes.
Message Structure
Program change messages have the structure CN XX, where N represents the MIDI channel
number and XX represents the program number.
Options
The following options are available:
{Channel}
This should match the MIDI Channel for the note command (1-16, 0-F). If set to Any, the
console will respond when any MIDI channel is sent a note command.
{Program Number}
The program number is any value between 0-127 (0-7F). Many devices will display this as 1-
128 – if this is the case for your other device, subtract one from the desired program number.
Control Change Events
Control Change commands were designed to represent specific actions on MIDI devices, like
pedals actuations and effects. For example, the Damper Pedal on a keyboard is often
represented by controller number 64 (hex 40). Similar to MIDI Note commands, the MIDI data
that is expected to be received is shown in the CIA and changes as you select event
parameters. When finished configuring the control change event, press {OK} to store the
event. Otherwise, press {Cancel} to undo the changes.
Message Structure
Program change messages have the structure BN XX YYY, where N represents the MIDI
channel number, XX represents the controller number, and YY represents the data byte.
To Next Page
Loading...
