Europlex 3GS - Page 179

3GS Technical Manual
Issue 4.5 August 2005
8-64 Programming Menus
RR
Power Up System Lost Power, now restored Unused
RS
Remote Program
Success
Successful connection made to 3GS Panel
with remote programming software
Unused
RX
Manual Test SIA Test Call (Time Command) Unused
TA
Tamper Alarm System Tamper Alarm – Enclosure opened Unused
TR
Tamper restoral System Tamper Restored – Enclosure
closed
Unused
YA
Bell Fault Bell Tamper detected Unused
YC
Communications
fail
Used with FTC Zone type – transmitted
when zone opened
Unused
YH
Bell Restoral Bell tamper restored Unused
YK
Communications
Restoral
Used with FTC Zone type – transmitted
when zone closed.
System Cable Fault restored
Unused
YM
System battery
Missing
System battery Missing/faulty Unused
YP
Power supply Trou-
ble
System power supply fault Unused
YQ
Power Supply
restored
System power supply fault restored Unused
YR
System Battery
restored
System battery fault restored Unused
YS
Communications
Troubl e
System Cable fault Unused
YW
WatchDog Reset Panel Auto Start (Reset switch activated) Unused
YX
Service required System requires Engineer service call Unused
YZ
Service Completed System service completed (Transmitted
when Engineer code is entered on System
following Service Required event)
Unused