EasyManua.ls Logo

Faro Edge - Page 61

Faro Edge
236 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FARO Edge
September 2012
47
Chapter 3: Operation
Establishing a FARO WLAN Connection
There are a minimum of three STAs to be configured. This may be performed in
any order but the typical order is:
1 Set up an Access Point
2 Set up the Edge
3 Set up the Host Computer
Access Point (AP)
Normally the Access Point is configured first. This setup may have been done
by the your IT department. If this is the case, IT should provide the Network
Name (SSID) and Password.
All Clients must use the same SSID and Password as the AP.
The recommended security setting is either WPA-PSK (TKIP encryption
algorithm) {Good} or WPA2-PSK (AES-CCMP encryption algorithm)
{Better, if available}. You should use a Password of 10 or more random
alphanumeric characters.
N
OTE: Wi-Fi Protected Access (WPA).
Fold-Down Touch Screen Controller - WLAN Client Setup Sequence
The AP should be configured and running. For steps to enable the Edge for
wireless communication, see “WiFi” on page 152.
The Host Computer Setup
The AP should be configured and running.
The ease of configuring client stations depends principally on the
configuration utility used. Windows XP comes with its own configuration
utility built in, Windows Zero Configuration Utility (WZC). However, there
are other configuration utilities that offer better efficiency, easier
configuration, and better wireless monitoring. Most Client cards come with
their own wireless configuration utility, though others depend on Windows.
Here we will describe the configuration of Client stations using WZC, which is
the lowest common denominator for most users.
1 Add preferred network - Enter SSID (example here is “My Network SSID”).
2 Configure Client to the same settings as the AP. To do so, click on the
PROPERTIES button. The S
ECURITY PROPERTIES dialog box appears. The
first text box will already be filled in with the SSID selected for the preferred
network name.
3 In the N
ETWORK AUTHENTICATION drop-down window, select WPA-PSK.
4 In the D
ATA ENCRYPTION drop-down window, select TKIP.
08M52E00_FaroArm_Edge.book Page 47 Thursday, October 4, 2012 9:31 AM

Table of Contents

Related product manuals