102
7.3 lldp mode
Command: lldp mode <send|receive|both|disable>
Function: Configure the operating state of LLDP function of the port.
Parameters: send: Configure the LLDP function as only being able to send messages.
receive: Configure the LLDP function as only being able to receive
messages.
both: Configure the LLDP function as being able to both send and receive
messages.
disable: Configure the LLDP function as not being able to send or receive
messages.
Default: The operating state of the port is ―both‖.
Command Mode: Port Configuration Mode.
Usage Guide: Choose the operating state of the lldp Agent on the port.
Example: Configure the state of port ethernet 1/5 of the switch as ―receive‖.
Switch(config)#in ethernet 1/5
Switch(Config-if-Ethernet 1/5)#lldp mode receive
7.4 lldp tx-interval
Command: lldp tx-interval <integer>
no lldp tx-interval
Function: Set the interval of sending update messages on all the ports with LLDP
function enabled, the value of which ranges from 5 to 32768 seconds and is 30 seconds
by default.
Parameters: <seconds> is the interval of sending updating messages, ranging from 5 to
32768 seconds.
Default: 30 seconds.
Command Settings: Global Mode.
Usage Guide: After configuring the interval of sending messages, LLDP messages can
only be received after a period as long as configured. The interval should be less than or
equal with half of aging time, for a too long interval will cause the state of being aged and
reconstruction happen too often; while a too short interval will increase the flow of the
network and decrease the bandwidth of the port. The value of the aging time of messages
is the product of the multiplier and the interval of sending messages. The maximum aging
time is 65535 seconds.
When tx-interval is the default value and transmit delay is configured via some commands,
To Next Page
Loading...
