76
Switch#rcommand commander
2.19 rcommand member
Command: rcommand member <mem-id>
Function: In the commander switch, this command is used to remotely manage the
member switches in the cluster.
Parameter: <mem-id> commander the member id allocated by commander to each
member, whose range is 1～128.
Command mode: Admin Mode.
Usage Guide: After executing this command, users will remotely login to a member
switch and enter Admin Mode on the latter. Use exit to quit the configuration interface of
the member. Because of the use of internal private IP, telnet authentication will be omitted
on member switches. This command can only be executed on commander switches.
Example: In the commander switch, enter the configuration interface of the member
switch with mem-id 1.
Switch#rcommand member 1
Chapter 3 Commands for Network Port
Configuration
3.1 Commands for Ethernet Port Configuration
3.1.1 bandwidth
Command: bandwidth control <bandwidth> {transmit | receive | both}
no bandwidth control
Function: Enable the bandwidth limit function on the port; the no command disables this
function.
Parameter: <bandwidth> is the bandwidth limit, which is shown in Mbps ranging
between 1-1000000K; both refers to the bandwidth limit when the port receives and
sends data, receive refers to the bandwidth limit will only performed when the switch
receives data from out side, while transmit refers to the function will be perform on
To Next Page
Loading...
