FoxGate S6124 - Show Ipv6 Enable; Commands for Arp Configuration; Arp

184
Frags: 0 reassembled, 0 timeouts
0 fragment rcvd, 0 fragment
dropped0 fragmented, 0 couldn't
fragment, 0 fragment sent
IPv6 fragmenting statistics
Sent: 110 generated, 0 forwarded
0 dropped, 0 no route
IPv6 sent packets statistics
15.2.14 show ipv6 enable
Command: show ipv6 enable
Function: Display IPv6 transmission function on/off status.
Parameter: None
Default: None
Command Mode: Admin and Configuration Mode
Example:
Switch#show ipv6 enable
ipv6 enable has been on
Displayed information
Explanation
ipv6 enable has been on
IPv6 transmission switch is at on status
15.3 Commands for ARP Configuration
15.3.1 arp
Command: arp <ip_address> <mac_address> {interface [ethernet] <portName>}
no arp <ip_address>
Function: Configures a static ARP entry; the ―no arp <ip_address>‖ command deletes a
ARP entry of the specified IP address.
Parameters: <ip_address> is the IP address, at the same filed with interface address;
<mac_address> is the MAC address; ethernet stands for Ethernet port; <portName> for
the name of layer2 port.
Default: No static ARP entry is set by default.
Command mode: VLAN Interface Mode
Usage Guide: Static ARP entries can be configured in the switch.
Example: Configuring static ARP for interface VLAN1.