360
no ntp access-group server <acl>
Function: To configure/cancel the access control list of NTP Server.
Parameter: <acl>: ACL number, range is from 1 to 99.
Default: Not configure the access control of NTP Server.
Command Mode: Global Mode.
Usage Guide: None.
Example: To configure access control list 2 on the switch.
Switch(config)#ntp access-group server 2
40.6 ntp authenticate
Command: ntp authenticate
no ntp authenticate
Function: To enable/cancel NTP authentication function.
Parameter: None.
Default: Disabled.
Command Mode: Global Mode.
Usage Guide: None.
Example: To enable NTP authentication function.
Switch(config)#ntp authenticate
40.7 ntp authentication-key
Command: ntp authentication-key <key-id> md5 <value>
no ntp authentication-key <key-id>
Function: To enable/cancel NTP authentication function, and defined NTP authentication
key.
Parameter: key-id: The id of key, range is from 1 to 4294967295.
value: The value of key, range between 1 to 16 of ascii code.
Default: The authentication key of NTP authentication is not configured by default.
Command Mode: Global Mode.
Usage Guide: None.
Example: To define the authentication key of NTP authentication, the key-id is 20, the
md5 is abc.
To Next Page
Loading...
