341
35.3 show ipv6 security-ra
Command: show ipv6 security-ra [interface <interface-list>]
Function: Display all the interfaces with IPv6 RA function enabled.
Parameters: No parameter will display all distrust ports, entering a parameter will display
the corresponding distrust port.
Command Mode: Admin and Configuration Mode.
Example:
Switch# show ipv6 security-ra
IPv6 security ra config and state information in the switch
Global IPv6 Security RA State: Enable
Ethernet1/1
IPv6 Security RA State: Yes
Ethernet1/3
IPv6 Security RA State: Yes
35.4 debug ipv6 security-ra
Command: debug ipv6 security-ra
no debug ipv6 security-ra
Function: Enable the debug information of IPv6 security RA; the no operation of this
command will disable the debug information of IPv6 security RA.
Command Mode: Admin Mode.
Parameters: None.
Usage Guide: Users can check the proceeds of message handling of IPv6 security RA,
which will help investigate the causes to problems if there is any.
Example: Enable the debug information of IPv6 security RA.
Switch#debug ipv security-ra
To Next Page
Loading...
