FoxGate S6124 - Ipv6 Mld Snooping Vlan Query-Robustness; Ipv6 Mld Snooping Vlan Static-Group

269
25.1.13 ipv6 mld snooping vlan query-robustness
Command: ipv6 mld snooping vlan <vlan-id> query-robustness <value>
no ipv6 mld snooping vlan <vlan-id> query-robustness
Function: Configure the query robustness; the ―no‖ form of this command restores to the
default value.
Parameter: vlan-id: VLAN ID, the valid range is <1-4094>
value: the valid range is <2-10>.
Command Mode: Global Mode
Default: 2
Usage Guide: It is recommended to use default value and if layer 3 MLD is in operation,
please make this configuration in accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 query- robustness 3
25.1.14 ipv6 mld snooping vlan static-group
Command: ipv6 mld snooping vlan<vlan-id> static-group <X:X::X:X> [source
<X:X::X:X>] interface [ethernet | port-channel] <IFNAME>
no ipv6 mld snooping vlan <vlan-id> static-group <X:X::X:X> [source
<X:X::X:X>] interface [ethernet | port-channel] <IFNAME>
Function: Configure static-group on specified port of the VLAN. The no form of the
command cancels this configuration.
Parameter: vlan-id: ranging between <1-4094>
X:X::X:X:The address of group or source.
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode: Global mode
Default: No configuration by default.
Usage Guide: When a group is a static while also a dynamic group, it should be taken as
a static group. Deleting static group can only be realized by the no form of the command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group ff1e::15 source 2000::1 interface
ethernet 1/1