FoxGate S6124 - Chapter 40 Commands for Ntp; Ntp Enable; Ntp Server

358
Chapter 40 Commands for NTP
40.1 ntp enable
Command: ntp enable
ntp disable
Function: To enable/disable NTP function globally.
Parameter: None.
Default: Disabled.
Command Mode: Global Mode.
Usage Guide: None.
Example: To enable NTP function.
Switch(config)#ntp enable
40.2 ntp server
Command: ntp server {<ip-address> | <ipv6-address>} [version <version_no>] [key
<key-id>]
no ntp server {<ip-address>|<ipv6-address>}
Function: To enable specified time server of time source, the no form of this command
cancels the specified time server of time source.
Parameter: ip-address: IPv4 address of time server.
ipv6-address: IPv6 address of time server.
version: The version information configured for server.
version_no: The version number of server, range is from 1 to 4, default is 4.
key: To configure key for server.
key-id: The key id.
Default: Disabled.
Command Mode: Global Mode.
Usage Guide: None.
Example: To configure time server address as 1.1.1.1 on switch.
Switch(config)#ntp server 1.1.1.1