FoxGate S6124 - Commands for Configuring Switch Ip; Interface Vlan; Interface Ethernet 0; Ip Address

43
Command: show telnet login
Function: Display the information of the Telnet client which currently establishes a Telnet
connection with the switch.
Command Mode: Admin and Configuration Mode.
Usage Guide: Check the Telnet client messages connected through Telnet with the
switch.
Example:
Switch#show telnet login
Authenticate login by local
Login user:
aa
1.3 Commands for Configuring Switch IP
1.3.1 interface vlan
Command: interface vlan <vlan-id>
no interface vlan <vlan-id>
Function: Enter the VLAN interface configuration mode; the no operation of this
command will delete the existing VLAN interface.
Parameters: <vlan-id> is the VLAN ID of an existing VLAN, ranging from 1 to 4094.
Command Mode: Global Configuration Mode.
Usage Guide: Users should first make sure the existence of a VLAN before configuring it.
User ―exit‖ command to quit the VLAN interface configuration mode back to the global
configuration mode.
Example: Enter the VLAN interface configuration mode of VLAN1.
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#
1.3.2 interface ethernet 0
This command is not supported by the switch.
1.3.3 ip address