364
address of time source and so on.
Parameter: None.
Default: None.
Command Mode: Admin and Configuration Mode.
Usage Guide: None.
Example:
Switch# show ntp status
Clock status: synchronized
Clock stratum: 3
Reference clock server: 1.1.1.2
Clock offset: 0.010 s
Root delay: 0.012 ms
Root dispersion: 0.000 ms
Reference time: TUE JAN 03 01:27:24 2006
40.16 show ntp session
Command: show ntp session [<ip-address> | <ipv6-address>]
Function: To display the information of all NTP session or one specific session, include
server ID, server layer, and the local offset according to server. (The symbol * means this
server is the selected local time source)
Parameter: ip-address: The IPv4 address of some specifics configured time server.
ipv6-address: The IPv6 address of some specifics configured time server.
If no parameter, the session relative information of all servers will be
displayed (Include broadcast and multicast servers)
Default: None.
Command Mode: Admin and Configuration Mode.
Usage Guide: None.
Example:
(Switch)# show ntp session
server stream type rootdelay rootdispersion trustlevel
* 1.1.1.2 2 unicast 0.010s 0.002s 10
2.2.2.2 3 unicast 0.005s 0.000s 10
To Next Page
Loading...
