30
Usage guide: When both this password and login command are configured, users have
to enter the password set by password command to enter normal user mode on console.
Example:
Switch(config)#password 0 test
Switch(config)#login
1.1.20 reload
Command: reload
Function: Warm reset the switch.
Command mode: Admin Mode.
Usage Guide: The user can use this command to restart the switch without power off.
1.1.21 service password-encryption
Command: service password-encryption
no service password-encryption
Function: Encrypt system password. The ―no service password-encryption‖ command
cancels the encryption.
Command mode: Global Mode
Default: No service password-encryption by system default
Usage guide: The current unencrypted passwords as well as the coming passwords
configured by password, enable password, ip ftp and username command will be
encrypted by executed this command. no service password-encryption cancels this
function however encrypted passwords remain unchanged.
Example: Encrypt system passwords
Switch(config)#service password-encryption
1.1.22 service terminal-length
Command: service terminal-length <0-512>
no service terminal-length
Function: Configure the columns of characters displayed in each screen on terminal (vty).
The ―no service terminal-length‖ command cancels the screen shifting operation.
Parameter: Columns of characters displayed on each screen of vty, ranging between
0-512.
Command mode: Global Mode
Usage guide: Configure the columns of characters displayed on each screen of the
To Next Page
Loading...
