124
access vlan‖ command deletes the current port from the specified VLAN, and the port will
be partitioned to VLAN1.
Parameter: <vlan-id> is the VID for the VLAN to be added the current port, valid range is
1 to 4094.
Command mode: Port Mode.
Default: All ports belong to VLAN1 by default.
Usage Guide: Only ports in Access mode can join specified VLANs, and an Access port
can only join one VLAN at a time.
Example: Add some Access port to VLAN100.
Switch(config)#interface ethernet 1/8
Switch(Config-If-Ethernet1/8)#switchport mode access
Switch(Config-If-Ethernet1/8)#switchport access vlan 100
Switch(Config-If-Ethernet1/8)#exit
10.1.14 switchport interface
Command: switchport interface [ethernet | portchannel] [interface-name |
interface-list]
no switchport interface [ethernet | portchannel] [interface-name |
interface-list]
Function: Specify Ethernet port to VLAN; the ―no switchport interface [ethernet |
portchannel] [<interface-name | interface-list>]‖ command deletes one or one set of
ports from the specified VLAN.
Parameter: ethernet is the Ethernet port to be added. portchannel means that the port
to be added is a link-aggregation port. interface-name port name, such as e1/1. If this
option is selected, ethernet or portchannel should not be. interface-list is the port list to
be added or deleted, ―;‖ and ―-‖ are supported, for example: ethernet1/1;3;4-7;8.
Command mode: VLAN Mode.
Default: A newly created VLAN contains no port by default.
Usage Guide: Access ports are normal ports and can join a VLAN, but a port can only join
one VLAN for a time.
Example: Assign Ethernet port 1, 3, 4-7, 8 of VLAN100.
Switch(Config-Vlan100)#switchport interface ethernet 1/1;3;4-7;8
10.1.15 switchport mode
Command: switchport mode {trunk | access}
Function: Set the port in access mode or trunk mode.
To Next Page
Loading...
