45
Switch(Config-if-Vlan1)#ipv6 address 2001:3f:ed8::99/64
1.3.5 ip bootp-client enable
Command: ip bootp-client enable
no ip bootp-client enable
Function: Enable the switch to be a BootP Client and obtain IP address and gateway
address through BootP negotiation; the ―no ip bootp-client enable‖ command disables
the BootP Client function and releases the IP address obtained in BootP.
Default: BootP client function is disabled by default.
Command mode: VLAN Interface Mode
Usage Guide: Obtaining IP address through BootP, Manual configuration and DHCP are
mutually exclusive, enabling any two methods for obtaining IP address is not allowed.
Note: To obtain IP address via BootP, a DHCP server or a BootP server is required in the
network.
Example: Get IP address through BootP.
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip bootp-client enable
Switch (Config-if-Vlan1)#exit
Switch(config)#
Relative command: ip address, ip dhcp-client enable
1.3.6 ip dhcp-client enable
Command: ip dhcp-client enable
no ip dhcp-client enable
Function: Enables the switch to be a DHCP client and obtain IP address and gateway
address through DHCP negotiation; the ―no ip dhcp-client enable‖ command disables
the DHCP client function and releases the IP address obtained in DHCP. Note: To obtain
IP address via DHCP, a DHCP server is required in the network.
Default: the DHCP client function is disabled by default.
Command mode: VLAN Interface Mode
Usage Guide: Obtaining IP address by DHCP, Manual configuration and BootP are
mutually exclusive, enabling any 2 methods for obtaining an IP address is not allowed.
Example: Getting an IP address through DHCP.
Switch(config)#interface vlan 1
To Next Page
Loading...
