99
6.11 debug uldp event
Command: debug uldp event
no debug uldp event
Function: Enable the message debug function to display the event; the no form
command disables this function.
Parameter: None.
Command Mode: Admin Mode.
Default: Disabled.
Usage Guide: Use this command to display all kinds of event information.
Example: Display event information.
Switch# debug uldp event
6.12 debug uldp packet
Command: debug uldp packet [receive|send]
no debug uldp packet [receive|send]
Function: Enable receives and sends packet debug function, after that. Display the type
and interface of the packet which receiving and sending on the client. The no form
command disables this function.
Parameter: None.
Command Mode: Admin Mode.
Default: Disabled.
Usage Guide: Use this command to display the packet that receiving on each interface.
Switch# debug uldp packet receive
6.13 debug uldp interface ethernet
Command: debug uldp {hello|probe|echo|unidir|all}[receive|send] interface
ethernet <IFname>
no debug uldp {hello|probe|echo|unidir|all}[receive|send] interface
ethernet <IFname>
Function: Enable the debug function of display the packet details. After that, display
some kinds of the packet details of terminal interface.
Parameter: <IFname>: Name of the interface.
Command Mode: Admin Mode.
To Next Page
Loading...
