31
terminal. The columns of characters displayed on each screen on the telent.ssh client and
the Console will be following this configuration.
Example: Set the number of vty threads to 20.
Switch(config)#service terminal-length 20
1.1.23 sysContact
Command: sysContact <LINE>
no sysContact
Function: Set the factory contact mode, the ―no sysContact‖ command reset the switch
to factory settings.
Parameter: <LINE> is the prompt character string, range from 0 to 255 characters.
Command mode: Global Mode
Default: The factory settings.
Usage guide: The user can set the factory contact mode bases the fact instance.
Example: Set the factory contact mode to test.
Switch(config)#sysContact test
1.1.24 sysLocation
Command: sysLocation <LINE>
no sysLocation
Function: Set the factory address, the ―no sysLocation‖ command reset the switch to
factory settings.
Parameter: <LINE> is the prompt character string, range from 0 to 255 characters.
Command mode: Global Mode
Default: The factory settings.
Usage guide: The user can set the factory address bases the fact instance.
Example: Set the factory address to test.
Switch(config)#sysLocation test
1.1.25 set default
Command: set default
Function: Reset the switch to factory settings.
Command mode: Admin Mode.
Usage Guide: Reset the switch to factory settings. That is to say, all configurations made
by the user to the switch will disappear. When the switch is restarted, the prompt will be
To Next Page
Loading...
