FoxGate S6124 - Ip Igmp Snooping Vlan Suppression-Query-Time; Show Ip Igmp Snooping

261
A.B.C.D: the address of group or source
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
Command Mode: Global mode
Default: No configuration by default.
Usage Guide: When a group is a static while also a dynamic group, it should be taken as
a static group. Deleting static group can only be realized by the no form of the command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group 224.1.1.1 source 192.168.1.1
interface ethernet 1/1
24.2.18 ip igmp snooping vlan suppression-query-time
Command: ip igmp snooping vlan <vlan-id> suppression-query-time <value>
no ip igmp snooping vlan <vlan-id> suppression-query-time
Function: Configure the suppression query time. The ―no ip igmp snooping vlan
<vlan-id> suppression-query-time‖ command restores to the default value.
Parameter: vlan-id: VLAN ID , ranging between <1-4094>
value: ranging between<1-65535> seconds
Command Mode: Global mode
Default: 255s
Usage Guide: This command can only be configured on L2 general querier. The
Suppression-query-time refers to the period of suppression state in which the querier
enters when receives query from the layer 3 IGMP in the segments.
Example: Switch(config)#ip igmp snooping vlan 2 suppression-query-time 270
24.2.19 show ip igmp snooping
Command: show ip igmp snooping [vlan <vlan-id>]
Parameter: <vlan-id> is the VLAN number specified for displaying IGMP Snooping
messages.
Command Mode: Admin Mode
Usage Guide: If no VLAN number is specified, it will show whether global IGMP Snooping
switch is on, which VLAN is configured with l2-general-querier function, and if a VLAN
number is specified, detailed IGMP messages for this VLAN will be shown.