FoxGate S6124 - Commands for Ipv6 Configuration; Clear Ipv6 Neighbor

174
Destination Mask Nexthop Interface Pref
C 2.2.2.0 255.255.255.0 0.0.0.0 vlan2 0
C 4.4.4.0 255.255.255.0 0.0.0.0 vlan4 0
S 6.6.6.0 255.255.255.0 9.9.9.9 vlan9 1
Displayed information
Explanation
C –connected
Direct route, namely the segment directly
connected with the layer 3 switch
S –static
Static route, the route manually configured
by users
R - RIP derived
RIP route, acquired by layer 3 switch
through the RIP protocol.
O - OSPF derived
OSPF route, acquired by layer 3 switch
through the OSPF protocol
A- OSPF ASE
Route introduced by OSPF
B- BGP derived
BGP route, acquired by the BGP protocol.
Destination
Target network
Mask
Target network mask
Nexthop
Next-hop IP address
Interface
Next-hop pass-by layer 3 swtich interfaces
Preference
Route priority. If other types of route to the
target network exists, the kernel route will
only shows those with high priority.
15.2 Commands for IPv6 configuration
15.2.1 clear ipv6 neighbor
Command: clear ipv6 neighbors
Function: Clear the neighbor cache of IPv6.
Parameter: None
Command Mode: Admin Mode
Default: None
Usage Guide: This command can not clear static neighbor.
Example: Clear neighbor list.
Switch#clear ipv6 neighbors