FoxGate S6124 - Permit | Deny(Mac Extended)

289
length of the IPv6 address prefix, the valid range is 1~128. <sIPv6Addr> is the source
IPv6 address.
Command Mode: Standard IPv6 nomenclature access list mode
Default: No access list configured by default.
Usage Guide:
Example: Permit packets with source address of 2001:1:2:3::1/64 while denying those
with source address of 2001:1:2:3::1/48.
Switch(config)#ipv6 access-list standard ipv6Flow
Switch(Config-IPv6-Std-Nacl-ipv6Flow)# permit 2001:1:2:3::1/64
Switch(Config-IPv6-Std-Nacl-ipv6Flow)# deny 2001:1:2:3::1/48
27.21 permit | deny(mac extended)
Command:
[no]{deny|permit} {any-source-mac|{host-source-mac <host_smac> }|{ <smac>
<smac-mask> }} {any-destination-mac|{host-destination-mac
<host_dmac> }|{ <dmac> <dmac-mask> }} [cos <cos-val> [ <cos-bitmask> ]]
[vlanId <vid-value> [ <vid-mask> ]] [ethertype <protocol> [ <protocol-mask> ]]
[no]{deny|permit} {any-source-mac|{host-source-mac <host_smac> }|{ <smac>
<smac-mask> }} {any-destination-mac|{host-destination-mac
<host_dmac> }|{ <dmac> <dmac-mask> }} [untagged-eth2 [ethertype <protocol>
[protocol-mask]]]
[no]{deny|permit}{any-source-mac|{host-source-mac <host_smac> }|{ <smac>
<smac-mask> }} {any-destination-mac|{host-destination-mac
<host_dmac> }|{ <dmac> <dmac-mask> }} [untagged-802-3]
[no]{deny|permit} {any-source-mac|{host-source-mac <host_smac> }|{ <smac>
<smac-mask> }} {any-destination-mac|{host-destination-mac
<host_dmac> }|{ <dmac> <dmac-mask> }} [tagged-eth2 [cos <cos-val>
[ <cos-bitmask> ]] [vlanId <vid-value> [ <vid-mask> ]] [ethertype <protocol>
[ <protocol-mask> ]]]
[no]{deny|permit}{any-source-mac|{host-source-mac <host_smac> }|{ <smac>
<smac-mask> }} {any-destination-mac|{host-destination-mac