259
Usage Guide: This command validates on dynamic mrouter ports but not on mrouter port.
To use this command, IGMP Snooping of this VLAN should be enabled previously.
Example: Switch(config)#ip igmp snooping vlan 2 mrpt 100
24.2.13 ip igmp snooping vlan query-interval
Command: ip igmp snooping vlan <vlan-id> query-interval <value>
no ip igmp snooping vlan <vlan-id> query-interval
Function: Configure this query interval.
Parameter: vlan-id: VLAN ID, ranging between <1-4094>
value: query interval, ranging between <1-65535>seconds
Command Mode: Global mode
Default: 125s
Usage Guide: It is recommended to use the default settings. Please keep this configure
in accordance with IGMP configuration as possible if layer 3 IGMP is running.
Example: Switch(config)#ip igmp snooping vlan 2 query-interval 130
24.2.14 ip igmp snooping vlan query-mrsp
Command: ip igmp snooping vlan <vlan-id> query-mrsp <value>
no ip igmp snooping vlan <vlan-id> query-mrsp
Function: Configure the maximum query response period. The ―no ip igmp snooping
vlan <vlan-id> query-mrsp‖ command restores to the default value.
Parameter: vlan-id: VLAN ID, ranging between <1-4094>
value: ranging between <1-25> seconds
Command Mode: Global mode
Default: 10s
Usage Guide: It is recommended to use the default settings. Please keep this configure
in accordance with IGMP configuration as possible if layer 3 IGMP is running.
Example:
Switch(config)#ip igmp snooping vlan 2 query-mrsp 18
24.2.15 ip igmp snooping vlan query-robustness
Command: ip igmp snooping vlan <vlan-id> query-robustness <value>
no ip igmp snooping vlan <vlan-id> query-robustness
Function: Configure the query robustness. The ―no ip igmp snooping vlan <vlan-id>
To Next Page
Loading...
