FoxGate S6124 - Chapter 39 Commands for Sntp; Debug Sntp

355
Agent address is 172.16.1.100
Address of the sFlow sample proxy is 172.16.1.100
Collector address have not
configured
the sFlow global analyzer address is not configured
Collector port is 6343
the sFlow global destination port is the defaulted 6343
Sampler priority is 2
The priority of sFlow when receiving packets from the
hardware is 2.
Sflow DataSource: type 2,
index 194(Ethernet1/1)
One sample proxy data source of the sFlow is the
interface e1/1 and its type is 2 (Ethernet), the interface
index is 194.
Collector address is
192.168.1.200
The analyzer address of the sampling address of the
E1/1 interface is 192.168.1.200
Collector port is 6343
Default value of the port on E1/1 interface sampling
proxy is 6343.
Counter interval is 20
The statistic sampling interval on e1/1 interface is 20
seconds
Sample rate is input 10000,
output 0
The ingress traffic rate of e1/1 interface sampling proxy
is 10000 and no egress traffic sampling will be
performed
Sample packet max len is 1400
The length of the sFlow group data sent by the e1/1
interface should not exceed 1400 bytes.
Sample header max len is 50
The length of the packet data head copied in the data
sampling of the e1/1 interface sampling proxy is 50
Sample version is 4
The datagram version of the sFlow group sent by the
E1/1 interface sampling proxy is 4.
Chapter 39 Commands for SNTP
39.1 debug sntp
Command: debug sntp {adjust | packet | select }
no debug sntp {adjust | packet | select}
Function: Displays or disables SNTP debug information.