FoxGate S6124 - Chapter 6 Commands for Uldp; Uldp Enable; Uldp Disable; Uldp Hello-Interval

95
Chapter 6 Commands for ULDP
6.1 uldp enable
Command: uldp enable
Function: ULDP will be enabled after issuing this command. In global configuration mode,
this command will enable ULDP for the global. In port configuration mode, this command
will enable ULDP for the port.
Parameters: None.
Command Mode: Global Configuration Mode and Port Configuration Mode.
Default: By default ULDP is not configured.
Usage Guide: ULDP can be configured for the ports only if ULDP is enabled globally. If
ULDP is enabled globally, it will be effect for all the existing fiber ports. For copper ports
and fiber ports which are available after ULDP is enabled, this command should be issued
in the port configuration mode to make ULDP be effect.
Example: To enable ULDP in global configuration mode.
Switch(config)#uldp enable
6.2 uldp disable
Command: uldp disable
Function: To disable ULDP configuration through this command.
Parameters: None.
Command Mode: Global Configuration Mode and Port Configuration Mode.
Default: By default ULDP is not configured.
Usage Guide: When ULDP is disabled globally, then ULDP in all the ports will be
disabled.
Example: To disable the ULDP configuration in global configuration mode.
Switch(config)#uldp disable
6.3 uldp hello-interval
Command: uldp hello-interval <integer>
no uldp hello-interval
Function: To configure the interval for ULDP to send hello messages. The no form of this