FoxGate S6124 - Lldp Notification Interval; Lldp Trap; Lldp Transmit Optional Tlv

104
7.7 lldp notification interval
Command: lldp notification interval <seconds>
no lldp notification interval
Function: When the time interval ends, the system is set to check whether the Remote
Table has been changed. If it has, the system will send Trap to the SNMP management
end.
Parameters: <seconds>is the time interval, ranging from 5 to 3600 seconds.
Default: The time interval is 5 seconds.
Command Mode: Global Mode.
Usage Guide: After configuring the notification time interval, a ―trap‖ message will be sent
at the end of this time interval whenever the Remote Table changes.
Example: Set the time interval of sending Trap messages as 20 seconds.
Switch(config)# lldp notification interval 20
7.8 lldp trap
Command: lldp trap <enable|disable>
Function: enable: configure to enable the Trap function on the specified port; disable:
configure to disable the Trap function on the specified port.
Parameters: None.
Default: The Trap function is disabled on the specified port by default.
Command Mode: Port Configuration Mode.
Usage Guide: The function of sending Trap messages is enabled on the port.
Example: Enable the Trap function on port ethernet 1/5 of the switch.
Switch(config)#in ethernet 1/5
Switch(Config-if-ethernet 1/5)# lldp trap enable
7.9 lldp transmit optional tlv
Command: lldp transmit optional tlv [portDesc] [sysName] [sysDesc] [sysCap]
no lldp transmit optional tlv
Function: Configure the type of optional TLV of the port.
Parameters: portDesc: the description of the port; sysName: the system name;
sysDesc: The description of the system; sysCap: the capability of the system.
Default: The messages carry no optional TLV by default.