154
13.2 class-map
Command: class-map <class-map-name>
no class-map <class-map-name>
Function: Creates a class map and enters class map mode; the ―no class-map
<class-map-name>‖ command deletes the specified class map.
Parameters: <class-map-name> is the class map name.
Default: No class map is configured by default.
Command mode: Global Mode
Usage Guide:
Example: Creating and then deleting a class map named ―c1‖.
Switch(config)#class-map c1
Switch(Config-ClassMap-c1)#exit
Switch(config)#no class-map c1
13.3 match
Command: match {access-group <acl-index-or-name> | ip dscp <dscp-list> | ip
precedence <ip-precedence-list>| ipv6 access-group <acl-index-or-name> | ipv6
dscp <dscp-list> | ipv6 flowlabel <flowlabel-list> | vlan <vlan-list> | cos<cost-list>}
no match {access-group | ip dscp | ip precedence | ipv6 access-group |
ipv6 dscp | ipv6 flowlabel | vlan | cos }
Function: Configure the match standard of the class map; the ―no‖ form of this command
deletes the specified match standard.
Parameter: access-group <acl-index-or-name> match specified IP ACL or MAC ACL,
the parameters are the number or name of the ACL; ip dscp <dscp-list> and ipv6 dscp
<dscp-list> match specified DSCP value, the parameter is a list of DSCP consisting of
maximum 8 DSCP values; ip precedence <ip-precedence-list> match specified IP
Precedence, the parameter is a IP Precedence list consisting of maximum 8 IP
Precedence values with a valid range of 0~7; ipv6 access-group <acl-index-or-name>
match specified IPv6 ACL, the parameter is the number or name of the IPv6 ACL; ipv6
flowlabel <flowlabel-list> match specified IPv6 flow label, the parameter is IPv6 flow
label value, the ranging is 0~1048575; vlan <vlan-list> match specified VLAN ID, the
parameter is a VLAN ID list consisting of maximum 8 VLAN IDs. <cost-list> match
specified CoS value, the parameter is a CoS list consisting of maximum 8 CoS.
Default: No match standard by default
Command Mode: Class-map Mode
To Next Page
Loading...
