118
Usage Guide: Use this command to enable GVRP debugging, GVRP packet processing
information can be displayed.
Example: Enable GVRP debugging.
Switch#debug gvrp
10.1.2 gvrp
Command: gvrp
no gvrp
Function: Enable the GVRP function for the switch or the current Trunk port; the ―no
gvrp‖ command disables the GVRP function globally or for the port.
Command mode: Port Mode and Global Mode.
Default: GVRP is disabled by default.
Usage Guide: Port GVRP can only be enabled after global GVRP is enabled. When
global GVRP is disabled, the GVRP configurations in the ports are also disabled. Note:
GVRP can only be enabled on Trunk ports.
Example: Enable the GVRP function globally and for Trunk port 10.
Switch(config)#gvrp
Switch(config)#interface ethernet 1/10
Switch(Config-If-Ethernet1/10)#gvrp
Switch(config)#exit
10.1.3 garp timer hold
Command: garp timer hold <timer-value>
no garp timer hold
Function: Set the hold timer for GARP; the ―no garp timer hold‖ command restores the
default timer setting.
Parameter: <timer-value> is the value for GARP hold timer, the valid range is 100 to
327650 ms.
Command mode: Port Mode.
Default: The default value for hold timer is 100 ms.
Usage Guide: When GARP application entities receive a join message, join message will
not be sent immediately. Instead, hold timer is started. After hold timer timeout, all join
messages received with the hold time will be sent in one GVRP frame, thus effectively
reducing protocol message traffic.
Example: Set the GARP hold timer value of port 1/10 to 500 ms.
Switch(Config-If-Ethernet1/10)#garp timer hold 500
To Next Page
Loading...
