316
Function: Set the AM IP segment of the interface, allow/deny the IP messages or APR
messages from a source IP within that segment to be forwarded via the interface.
Parameters: <ip-address> the starting address of an address segment in the IP address
pool; <num> is the number of consecutive addresses following ip-address, less than or
equal with 32.
Default: IP address pool is empty.
Command Mode: Port Mode.
Usage Guide: None.
Example: Configure that interface 1/3 of the switch will forward data packets from an IP
address which is one of 10 consecutive IP addresses starting from 10.10.10.1.
Switch(Config-If-Ethernet 1/3)#am ip-pool 10.10.10.1 10
30.4 am mac-ip-pool
Command: am mac-ip-pool <mac-address> < ip-address>
no am mac-ip-pool <mac-address> < ip-address>
Function: Set the AM MAC-IP address of the interface, allow/deny the IP messages or
APR messages from a source IP within that segment to be forwarded via the interface.
Parameter: <mac-address> is the source MAC address; < ip-address> is the source IP
address of the packets, which is a 32 bit binary number represented in four decimal
numbers.
Default: MAC-IP address pool is empty.
Command Mode: Port Mode.
Usage Guide: None.
Example: Configure that the interface 1/3 of the switch will allow data packets with a
source MAC address of 11-22-22-11-11-11 and a source IP address of 10.10.10.1 to be
forwarded.
Switch(Config-If-Ethernet1/3)#am mac-ip-pool 11-22-22-11-11-11 10.10.10.1
30.5 no am all
Command: no am all [ip-pool | mac-ip-pool]
Function: Delete MAC-IP address pool or IP address pool or both pools configured by all
users.
Parameters: ip-pool is the IP address pool; mac-ip-pool is the MAC-IP address pool; no
parameter means both address pools.
Default: Both address pools are empty at the beginning.
To Next Page
Loading...
