FoxGate S6124 - Rcommand Commander

75
----------------------------------------------
Switch#show cluster topology nodes-sn 2
Toplogy role: Member
Member status: Active member (user-config)
SN: 2
MAC Address: 01-02-03-04-05-02
Description: ES4626H
Hostname : LAB_SWITCH_2
Upstream local-port: eth 1/1
Upstream node: 01-02-03-04-05-01
Upstream remote-port:eth 1/2
Upstream speed: 100full
Switch#
----------------------------------------------
Switch#show cluster topology mac-address 01-02-03-04-05-02
Toplogy role: Member
Member status: Active member (user-config)
SN: 2
MAC Address: 01-02-03-04-05-02
Description: ES4626H
Hostname : LAB_SWITCH_2
Upstream local-port: eth 1/1
Upstream node: 01-02-03-04-05-01
Upstream remote-port:eth 1/2
Upstream speed: 100full
2.18 rcommand commander
Command: rcommand commander
Function: In the member switch, use this command to configure the commander switch.
Command mode: Admin Mode.
Instructions: This command is used to configure the commander switch remotely. Users
have to telnet the commander switch by passing the authentication. The command ―exit‖
is used to quit the configuration interface of the commander switch. This command can
only be executed on member switches.
Example: In the member switch, enter the configuration interface of the commander
switch.