FoxGate S6124 - Debug Mrpp; Enable

343
36.3 debug mrpp
Command: debug mrpp
no debug mrpp
Function: Open MRPP debug information; ―no description‖ command disables MRPP
debug information.
Command Mode: Admin Mode
Parameter: None.
Usage Guide: Enable MRPP debug information, and check message process of MRPP
protocol and receive data packet process, it is helpful to monitor debug.
Example: Enable debug information of MRPP protocol.
Switch#debug mrpp
36.4 enable
Command: enable
no enable
Function: Enable configured MRPP ring, the ―no enable‖ command disables this enabled
MRPP ring.
Parameter:
Command Mode: MRPP ring mode
Default: Default disable MRPP ring.
Usage Guide: Executing this command, it must enable MRPP protocol, and if other
commands have configured, the MRPP ring is enabled.
Example: Configure MRPP ring 4000 of switch to primary node, and enable the MRPP
ring.
Switch(config)#mrpp enable
Switch(config)#mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000
Switch(mrpp-ring-4000)# node-mode master
Switch(mrpp-ring-4000)#fail-timer 18
Switch(mrpp-ring-4000)#hello-timer 6
Switch(mrpp-ring-4000)#enable
Switch(mrpp-ring-4000)#exit
Switch(config)#in ethernet 1/1
Switch(config-If-Ethernet1/1)#mrpp ring 4000 primary-port
Switch(config)#in ethernet 1/3