FoxGate S6124 - Show Access-Lists

293
destination MAC address, any source IP address and destination IP address, and source
port 100.
Switch(config)# mac-ip-access-list extended macIpExt
Switch(Config-MacIp-Ext-Nacl-macIpExt)# deny any-source-mac any-destination-mac
udp any-source s-port 100 any-destination
27.23 show access-lists
Command: show access-lists [<num>|<acl-name>]
Functions: Reveal ACL of configuration.
Parameters: <acl-name>, specific ACL name character string; <num>, specific ACL No.
Default: None.
Command Mode: Admin Mode
Usage Guide: When not assigning names of ACL, all ACL will be revealed, used x time
（s）indicates the times of ACL to be used.
Examples:
Switch#show access-lists
access-list 10(used 0 time(s))
access-list 10 deny any-source
access-list 100(used 1 time(s))
access-list 100 deny ip any any-destination
access-list 100 deny tcp any any-destination
access-list 1100(used 0 time(s))
access-list 1100 permit any-source-mac any-destination-mac tagged-eth2 14 2 0800
Displayed information
Explanation
access-list 10(used 1 time(s))
Number ACL10, 0 time to be used
access-list 10 deny any
Deny any IP packets to pass
access-list 100(used 1 time(s))
Nnumber ACL100, 1 time to be used
access-list 100 deny ip any
any-destination
Deny IP packet of any source IP address
and destination address to pass
access-list 100 deny tcp any
any-destination
Deny TCP packet of any source IP address
and destination address to pass
access-list 1100 permit any-source-mac
Permit tagged-eth2 with any source MAC