FoxGate S6124 - Debug Uldp Fsm Interface Ethernet; Debug Uldp Error

98
Parameters: <interface-name>is the interface name.
Command Mode: Admin and Configuration Mode.
Default: None.
Usage Guide: If no parameters are appended, the global ULDP information will be
displayed. If the interface name is specified, information about the interface and its
neighbors will be displayed along with the global information.
Example: To display the global ULDP information.
Switch(config)# show uldp
6.9 debug uldp fsm interface ethernet
Command: debug uldp fsm interface ethernet <IFname>
no debug uldp fsm interface ethernet <IFname>
Function: To enable debugging information for ULDP for the specified interface. The no
form of this command will disable the debugging information.
Parameters: <IFname> is the interface name.
Command Mode: Admin Configuration Mode.
Default: Disabled by default.
Usage Guide: This command can be used to display the information about state
transitions of the specified interfaces.
Example: Print the information about state transitions of interface ethernet 1/1.
Switch#debug uldp fsm interface ethernet 1/1
6.10 debug uldp error
Command: debug uldp error
no debug uldp error
Function: Enable the error message debug function, the no form command disable the
function.
Parameter: None.
Command Mode: Admin Mode.
Default: Disabled.
Usage Guide: Use this command to display the error message.
Example: Display the error message.
Switch#debug uldp error