FoxGate S6124 - Chapter 45 Detailed Information on Changes

389
Examples: Display the current PoE status on port 1 to port 6.
Switch# show power inline interface ethernet 1/1-6
Interface Status Oper Power(mW) Max(mW) Current(mA) Volt(V) Priority Class
------------ ------- ------ --------- ------- ----------- ------- -------- -----
Ethernet1/1 enable off 0 15400 0 0 high 0
Ethernet1/2 enable off 0 15400 0 0 low 0
Ethernet1/3 enable off 0 15400 0 0 low 0
Ethernet1/4 enable off 0 15400 0 0 low 0
Ethernet1/5 enable off 0 15400 0 0 low 0
Ethernet1/6 enable off 0 15400 0 0 low 0
44.2.1.3 debug power inline
Command: debug power inline
no debug power inline
Function: Enable or disable the PoE debugging.
Parameters: None.
Command Mode: Admin Mode.
Default: None.
Usage Guide: With debugging enabled, relative information will be printed in the key
processes while implementing commands, for further debugging reference whenever an
error occurs. The ―no‖ command will disable the debugging.
Examples: Enable PoE debugging.
Switch#debug power inline
Chapter 45 Detailed information on
changes
 Added ―EFM OAM‖ operation and command.
 Deleted command ―ethernet-oam remote-loopback‖, ―ethernet-oam
remote-loopback supported‖, ―show ethernet-oam loopback status‖.
 Deleted ―EFM OAM‖ basic configuration.
 Enabled ―EFM OAM‖ port loopback configuration commands and appropriate
instructions.
 In the instruction to the command ―mac-address-table aging-time‖ phrase
―entry will be deleted‖ changed to ―entry will be aged‖.