FoxGate S6124 - Ipv6 Nd Ns-Interval; Ipv6 Neighbor

178
Duplicate Address Detection, and the value of <value> must be in 0-10, NO command
restores to default value 1.
Command Mode: Interface Configuration Mode
Default: The default request message number is 1.
Usage Guide: When configuring an IPv6 address, it is required to process IPv6 Duplicate
Address Detection, this command is used to configure the ND message number of
Duplicate Address Detection to be sent, value being 0 means no Duplicate Address
Detection is executed.
Example: The Neighbor Solicitation Message number sent in succession by interface
when setting Duplicate Address Detection is 3.
Switch(Config-if-Vlan1)# ipv6 nd dad attempts 3
15.2.8 ipv6 nd ns-interval
Command: ipv6 nd ns-interval <seconds>
no ipv6 nd ns-interval
Function: Set the time interval of Neighbor Solicitation Message sent by the interface.
Parameter: parameter <seconds> is the time interval of sending Neighbor Solicitation
Message, <seconds> value must be between 1-3600 seconds, no command restores the
default value 1 second.
Command Mode: Interface Configuration Mode
Default: The default Request Message time interval is 1 second.
Default: The value to be set will include the situation in all routing announcement on the
interface. Generally, very short time interval is not recommended.
Example: Set Vlan1 interface to send out Neighbor Solicitation Message time interval to
be 8 seconds.
Switch(Config-if-Vlan1)#ipv6 nd ns-interval 8
15.2.9 ipv6 neighbor
Command: ipv6 neighbor <ipv6-address> <hardware-address> interface
<interface-type interface-name>
no ipv6 neighbor <ipv6-address>
Function: Set static neighbor table entry.
Parameters: Parameter ipv6-address is static neighbor IPv6 address, parameter
hardware-address is static neighbor hardware address, interface-type is Ethernet type,
interface-name is Layer 2 interface name.
Command Mode: Interface Configuration Mode