179
Default Situation: There is not static neighbor table entry.
Usage Guide: IPv6 address and multicast address for specific purpose and local address
can not be set as neighbor.
Example: Set static neighbor 2001:1:2::4 on port E1/1, and the hardware MAC address is
00-03-0f-89-44-bc.
Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-03-0f-89-44-bc interface Ethernet
1/1
15.2.10 show ipv6 interface
Command: show ipv6 interface {brief|<interface-name>}
Function: Show interface IPv6 parameters.
Parameter: Parameter brief is the brief summarization of IPv6 status and configuration,
and parameter interface-name is Layer 3 interface name.
Default: None
Command Mode: Admin and Configuration Mode
Usage Guide: If only brief is specified, then information of all L3 is displayed, and you can
also specify a specific Layer 3 interface.
Example:
Switch#show ipv6 interface Vlan1
Vlan1 is up, line protocol is up, dev index is 2004
Device flag 0x1203(UP BROADCAST ALLMULTI MULTICAST)
IPv6 is enabled
Link-local address(es):
fe80::203:fff:fe00:10 PERMANENT
Global unicast address(es):
3001::1 subnet is 3001::1/64 PERMANENT
Joined group address(es):
ff02::1
ff02::16
ff02::2
ff02::5
ff02::6
ff02::9
ff02::d
ff02::1:ff00:10
ff02::1:ff00:1
MTU is 1500 bytes
To Next Page
Loading...
