EasyManua.ls Logo

FoxGate S6124 - Ipv6 Address

Default Icon
391 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44
Command: ip address <ip-address> <mask> [secondary]
no ip address [<ip-address> <mask>] [secondary]
Function: Set the IP address and mask for the specified VLAN interface; the no ip
address <ip address> <mask> [secondary] command deletes the specified IP address
setting.
Parameter: <ip-address> is the IP address in dot decimal format; <mask> is the subnet
mask in dot decimal format; [secondary] indicates the IP configured is a secondary IP
address.
Default: No IP address is configured upon switch shipment.
Command mode: VLAN Interface Mode
Usage Guide: A VLAN interface must be created first before the user can assign an IP
address to the switch.
Example: Set 10.1.128.1/24 as the IP address of VLAN1 interface.
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip address 10.1.128.1 255.255.255.0
Switch(Config-if-Vlan1)#exit
Switch(config)#
Relative Command: ip bootp-client enable, ip dhcp-client enable
1.3.4 ipv6 address
Command: ipv6 address <ipv6address | prefix-length> [eui-64]
no ipv6 address <ipv6address | prefix-length> [eui-64]
Function: Configure aggregatable global unicast address, site-local address and
link-local address for the interface.
Parameters: <ipv6address> is the prefix of an IPV6 address; <prefix-length>is the
length of the prefix of an IPV6 address, ranging from 3 to 128; eui-64 means that the eui64
interface id of the interface will automatically create an IPV6 address.
Command Mode: Interface Configuration Mode.
Default: None.
Usage Guide: The prefix of an IPV6 address should not be a multicast address, or other
kinds of IPV6 addresses with specific usage. Different layer-three VLAN interfaces are
forbidden to share a same address prefix. As for any global unicast address, the prefix
should be limited in the range from 2001:: to 3fff ::,with a length no shorter than 3. And the
prefix length of a site-local address or a link-local address should not be shorter than 10.
Examples: Configure an IPV6 address at the layer-three interface of VLAN1: set the
prefix as 2001:3f:ed8::99, the length of which is 64.

Table of Contents

Related product manuals