EasyManua.ls Logo

FoxGate S6124 - Netbios-Node-Type; Network-Address

Default Icon
391 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
208
Command Mode: DHCP Address Pool Mode
Usage Guide: This command is used to specify WINS server for the client, up to 8 WINS
server addresses can be configured. The WINS server address assigned first has the
highest priority. Therefore, address 1 has the highest priority, and address 2 the second,
and so on.
Example: Setting the server address of DHCP pool ―1‖ to 192.168.1.1.
Switch(dhcp-1-config)#netbios-name-server 192.168.1.1
20.1.20 netbios-node-type
Command: netbios-node-type {b-node | h-node | m-node | p-node | <type-number>}
no netbios-node-type
Function: Sets the node type for the specified port; the no netbios-node-type
command cancels the setting.
Parameters: b-node stands for broadcasting node, h-node for hybrid node that
broadcasts after point-to-point communication; m-node for hybrid node to communicate in
point-to-point after broadcast; p-node for point-to-point node; <type-number> is the node
type in Hex from 0 to FF.
Default: No client node type is specified by default.
Command Mode: DHCP Address Pool Mode
Usage Guide: If client node type is to be specified, it is recommended to set the client
node type to h-node that broadcasts after point-to-point communication.
Example: Setting the node type for client of pool 1 to broadcasting node.
Switch(dhcp-1-config)#netbios-node-type b-node
20.1.21 network-address
Command: network-address <network-number> [<mask> | <prefix-length>]
no network-address
Function: Sets the scope for assignment for addresses in the pool; the no
network-address‖ command cancels the setting.
Parameters: <network-number> is the network number; <mask> is the subnet mask in
the decimal format; <prefix-length> stands for mask in prefix form. For example, mask
255.255.255.0 in prefix is ―24‖, and mask 255.255.255.252 in prefix is ―30‖. Note: When
using DHCP server, the pool mask should be longer or equal to that of layer 3 interface IP
address in the corresponding segment.
Default: If no mask is specified, default mask will be assigned according to the address
class.

Table of Contents

Related product manuals