FoxGate S6124 - Debug Ipv6 Dhcp Client Packet; Debug Ipv6 Dhcp Detail; Debug Ipv6 Dhcp Relay Packet; Debug Ipv6 Dhcp Server

214
21.3 debug ipv6 dhcp client packet
Command: debug ipv6 dhcp client {event | packet}
no debug ipv6 dhcp client {event | packet}
Function: To enable the debugging messages for protocol packets of DHCPv6 prefix
delegation client, the no form of this command will disable the debugging information.
Default: Disabled.
Command Mode: Admin Mode.
Example:
Switch# debug ipv6 dhcp client packet
21.4 debug ipv6 dhcp detail
Command: debug ipv6 dhcp detail
no debug ipv6 dhcp detail
Function: To display the debug information of all kinds of packets received or sent by
DHCPv6, the no form of this command disabled this function.
Default: Disabled.
Command Mode: Admin Mode.
Example:
Switch# debug ipv6 dhcp detail
21.5 debug ipv6 dhcp relay packet
This command is not supported by switch.
21.6 debug ipv6 dhcp server
Command: debug ipv6 dhcp server { event | packet }
no debug ipv6 dhcp server { event | packet }
Function: To enable the debugging information of DHCPv6 server, the no form of this
command will disable the debugging.
Parameter: event is to enable debugging messages for DHCPv6 server events, such as
address allocation; packet is for debugging messages of protocol packets of DHCPv6
server.
Default: Disabled.