362
Parameter: None.
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: To display NTP authentication information, if the switch is enabled, and if
the packets schlepped authentication information when the packet in sending or receiving
process, then the key identifier will be printed out.
Example: To enable the switch of displaying NTP authentication information.
Switch# debug ntp authentication
40.11 debug ntp packet
Command: debug ntp packet [send | receive]
no debug ntp packet [send | receive]
Function: To enable/disable the debug switch of displaying NTP packet information.
Parameter: send: The debug switch of sending NTP packet.
receive: The debug switch of receiving NTP packet.
If there is no parameter, that means should enable the sending and receiving
switch of NTP packet in the same time.
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: None.
Example: To enable the debug switch of displaying NTP packet information.
Switch# debug ntp packet
40.12 debug ntp adjust
Command: debug ntp adjust
no debug ntp adjust
Function: To enable/disable the debug switch of displaying local time adjust information.
Parameter: None.
Default: Disabled.
Command Mode: Admin Mode.
Usage Guide: None.
Example: To enable the debug switch of displaying local time adjust information.
To Next Page
Loading...
