FoxGate S6124 - Ipv6 Mld Snooping Vlan Query-Interval; Ipv6 Mld Snooping Vlan Query-Mrsp

268
no ipv6 mld snooping vlan <vlan-id> mrpt
Function: Configure the keep-alive time of the mrouter port.
Parameter: vlan-id: VLAN ID, the valid range is <1-4094>
value: mrouter port keep-alive time with a valid range of <1-65535> secs.
Command Mode: Global Mode
Default: 255s
Usage Guide: This configuration is applicable on dynamic mrouter port, but not on static
mrouter port. To use this command, MLD snooping must be enabled on the VLAN.
Example: Switch(config)#ipv6 mld snooping vlan 2 mrpt 100
25.1.11 ipv6 mld snooping vlan query-interval
Command: ipv6 mld snooping vlan <vlan-id> query-interval <value>
no ipv6 mld snooping vlan <vlan-id> query-interval
Function: Configure the query interval.
Parameter: vlan-id: VLAN ID, the valid range is <1-4094>
value: query interval, valid range: <1-65535>secs.
Command Mode: Global Mode
Default: 125s
Usage Guide: It is recommended to use default value and if layer 3 MLD is in operation,
please make this configuration in accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 query-interval 130
25.1.12 ipv6 mld snooping vlan query-mrsp
Command: ipv6 mld snooping vlan <vlan-id> query-mrsp <value>
no ipv6 mld snooping vlan <vlan-id> query-mrsp
Function: Configure the maximum query response period. The ―no‖ form of this
command restores the default value.
Parameter: vlan-id: VLAN ID, the valid range is<1-4094>
value: the valid range is <1-25> secs .
Command Mode: Global Mode
Default: 10s
Usage Guide: It is recommended to use default value and if layer 3 MLD is in operation,
please make this configuration in accordance with the MLD configuration as possible.
Example:
Switch(config)#ipv6 mld snooping vlan 2 query-mrsp 18