FoxGate S6124 - Ip Multicast Destination-Control Access-Group

247
<destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
no access-list <5000-5099> {deny|permit} ip {{<source>
<source-wildcard>}|{host <source-host-ip>}|any} {{<destination>
<destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
Function: Configure source control multicast access-list; the ―no access-list
<5000-5099> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any-source} {{<destination>
<destination-wildcard>}|{host-destination <destination-host-ip>}|any-destination}‖
command deletes the access-list.
Parameter: <5000-5099>: source control access-list number.
{deny|permit}: deny or permit.
<source>: multicast source address..
<source-wildcard>: multicast source address wildcard character.
<source-host-ip>: multicast source host address.
<destination>: multicast destination address.
<destination-wildcard>: multicast destination address wildcard character.
<destination-host-ip>: multicast destination host address.
Default: None
Command Mode: Global Mode
Usage Guide: ACL of Multicast source control list item is controlled by specifical ACL
number from 5000 to 5099, the command applies to configure this ACL. ACL of Multicast
source control only needs to configure source IP address and destination IP address
controlled (group IP address), the configuration mode is basically the same to other ACLs,
and use wildcard character to configure address range, and also specify a host address or
all address. Remarkable, ―all address‖ is 224.0.0.0/4 according to group IP address, not
0.0.0.0/0 in other access-list.
Example: Switch(config)#access-list 5000 permit ip 10.1.1.0 0.0.0.255 232.0.0.0
0.0.0.255
24.1.3 ip multicast destination-control access-group
Command: ip multicast destination-control access-group <6000-7999>
no ip multicast destination-control access-group <6000-7999>
Function: Configure multicast destination-control access-list used on interface, the ―no ip
multicast destination-control access-group <6000-7999>― command deletes the
configuration.