FoxGate S6124 - Chapter 13 Commands for Qos; Class

153
no debug spanning-tree
Function: Enable the MSTP debugging information; the command ―no debug
spanning-tree‖ disables the MSTP debugging information.
Command mode: Admin Mode
Usage Guide: This command is the general switch for all the MSTP debugging. Users
should enable the detailed debugging information, then they can use this command to
display the relevant debugging information. In general, this command is used by skilled
technicians.
Example: Enable to receive the debugging information of BPDU messages on the
port1/1.
Switch#debug spanning-tree
Switch#debug spanning-tree bpdu rx interface e1/1
Chapter 13 Commands for QoS
13.1 class
Command: class <class-map-name>
no class <class-map-name>
Function: Associates a class to a policy map and enters the policy class map mode; the
―no class <class-map-name>‖ command deletes the specified class.
Parameters: < class-map-name> is the class map name used by the class.
Default: No policy class is configured by default.
Command mode: Policy map configuration Mode
Usage Guide: Before setting up a policy class, a policy map should be created and the
policy map mode entered. In the policy map mode, classification and policy configuration
can be performed on packet traffic classified by class map.
Example: Entering a policy class mode.
Switch(config)#policy-map p1
Switch(Config-PolicyMap-p1)#class c1
Switch(Config-PolicyMap-p1-Class-c1)#exit