194
16.11 debug anti-arpscan
Command: debug anti-arpscan [port | ip]
no debug anti-arpscan [port | ip]
Function: Enable the debug switch of ARP scanning prevention; ‖no debug
anti-arpscan [port | ip]‖ command disables the switch.
Parameters: None.
Default Settings: Disable the debug switch of ARP scanning prevention
Command Mode: Admin Mode
User Guide: After enabling debug switch of ARP scanning prevention users can check
corresponding debug information or enable the port-based or IP-based debug switch
separately whenever a port is closed by ARP scanning prevention or recovered
automatically, and whenever IP t is closed or recovered .
Example: Enable the debug function for ARP scanning prevention of the switch.
Switch(config)#debug anti-arpscan
To Next Page
Loading...
