32
the same as when the switch was powered on for the first time.
Note: After the command, ―write‖ command must be executed to save the operation. The
switch will reset to factory settings after restart.
Example:
Switch#set default
Are you sure? [Y/N] = y
Switch#write
Switch#reload
1.1.26 setup
Command: setup
Function: Enter the Setup Mode of the switch.
Command mode: Admin Mode.
Usage Guide: Switch provides a Setup Mode, in which the user can configure IP
addresses, etc.
1.1.27 show clock
Command: show clock
Function: Display the current system clock.
Command mode: Admin and Configuration Mode.
Usage Guide: If the system clock is inaccurate, user can adjust the time by examining the
system date and clock.
Example:
Switch#show clock
Current time is TUE AUG 22 11：00：01 2002
Command related: clock set
1.1.28 show temperature
This command is not supported by switch.
1.1.29 show tech-support
Command: show tech-support [no-more]
Function: Display the operational information and the task status of the switch. The
technique specialist use this command to diagnose whether the switch operate normally.
Parameter: no-more: Display the operational information and the task status of the
To Next Page
Loading...
