FoxGate S6124 - Debug Lldp Packets; Clear Lldp Remote-Table

109
7.18 debug lldp packets
Command: debug lldp packets interface ethernet <IFNAME>
no debug lldp packets interface ethernet <IFNAME>
Function: Display the message-receiving and message-sending information of LLDP on
the port; the no operation of this command will disable the debug information switch.
Parameters: None.
Default: Disable the debug information on the port.
Command Mode: Admin Mode.
Usage Guide: When the debug switch is enabled, users can check the receiving and
sending of packets and other information on the port.
Example: Enable the debug switch of LLDP function on the switch.
Switch(config)# debug lldp packets interface ethernet 1/1
%Jan 01 00:02:40 2006 LLDP-PDU-TX PORT= ethernet 1/1.
7.19 clear lldp remote-table
Command: clear lldp remote-table
Function: Clear the Remote-table on the port.
Parameters: None.
Default: Do not clear the entries.
Command Mode: Port Configuration Mode.
Usage Guide: Clear the Remote table entries on this port.
Example: Clear the Remote table entries on this port.
Switch(Config-Ethernet 1/1)# clear lldp remote-table