FoxGate S6124 - Ip User Private Packet Version Two; Ip User Helper-Address

238
password should be configured on TrustView server.
Example: Enable encrypt or hash function of private message.
Switch(config)# enable trustview key 0 foxgate
22.20 ip user private packet version two
Command: ip user private packet version two
no ip user private packet version two
Function: The switch choose private packet version two to communicate with trustview.
Parameter: None.
Command Mode: Global Mode.
Default: The switch choose private packet version one to communicate with DCBI.
Usage Guide: If the DCBI access control system is applied, the switch should be
configured to use private protocol of version one to communicate with the DCBI server.
However, if TrustView is applied, version two should be applied.
Example: To configure the switch choose private packet version two to communicate with
FOXGATE inter security management background system.
switch(config)#ip user private packet version two
22.21 ip user helper-address
Command: ip user helper-address <svr_addr> [port <udp_port>] source
<src_addr> [secondary]
no ip user helper-address [secondary]
Function: Set the address and port of HELPER SERVER.
Parameters:
<svr_addr>: The IP address of HELPER SERVER 的 IP in dotted-decimal
notation.
udp_port: The UDP port of HELPER SERVER, the range of which is1－
65535, and its default value is 9119.
src_addr: The local management IP address of the switch, in
dotted-decimal notation.
sencondary: Whether it is a secondary SERVER address.
Command Mode: Global mode
Default Settings: There is no HELPER SERVER address by default.