383
43.7 debug driver
Command: debug driver {receive | send} [interface {<interface-name> | all}]
[protocol {<protocol-type> | discard | all}] [detail]
no debug driver {receive | send}
Function: Turn on the on-off of showing the information of the CPU receiving or sending
packets, the ―no debug driver {receive | send}‖ command turn off the on-off.
Parameter: receive | send show the information of receiving or sending packets;
interface {<interface-list>| all}: interface-list is the Ethernet port number, all indicate all
the Ethernet ports.
protocol {<protocol-type> | discard | all}: protocol-type is the type of the protocol of the
packet, including snmp、telnet、http、dhcp、igmp、arp、ssh、icmpv6、dot1x、gvrp、
stp、lacp、cluster、eapou, all means all of the protocol types, discard means all the
discarded packets.
Detail show detail information.
Command Mode: Admin Mode
Usage Guide: This command is used to debug, it is supposed to be used with the help of
the technical support.
Example: Turn on the on-off for showing the receiving packets.
Switch#debug driver receive
Chapter 44 Commands for PoE
44.1 Commands for PoE Configuration
44.1.1 power inline enable (Global)
Command: power inline enable
no power inline enable
Function: Enable /disable global PoE.
Parameters: None.
Command Mode: Global Mode.
Default: Global PoE is enabled.
Usage Guide: With PoE globally disabled, there would be no power output no matter
To Next Page
Loading...
