103
tx-interval will become four times of the latter, instead of the default 40.
Example: Set the interval of sending messages as 40 seconds.
Switch(config)# lldp tx-interval 40
7.5 lldp msgTxHold
Command: lldp msgTxHold <value>
no lldp msgTxHold
Function: Set the multiplier value of the aging time carried by update messages sent by
the all ports with LLDP function enabled, the value ranges from 2 to 10.
Parameters: <value> is the aging time multiplier, ranging from 2 to 10.
Default: the value of the multiplier is 4 by default.
Command Mode: Global Mode.
Usage Guide: After configuring the multiplier, the aging time is defined as the product of
the multiplier and the interval of sending messages, and its maximum value is 65535
seconds.
Example: Set the value of the aging time multiplier as 6.
Switch(config)#lldp msgTxHold 6
7.6 lldp transmit delay
Command: lldp transmit delay <seconds>
no lldp transmit delay
Function: Since local information might change frequently because of the variability of
the network environment, there could be many update messages sent in a short time. So
a delay is required to guarantee an accurate statistics of local information.
When transmit delay is the default value and tx-interval is configured via some commands,
transmit delay will become one fourth of the latter, instead of the default 2.
Parameters: <seconds>is the time interval, ranging from 1 to 8192 seconds.
Default: The interval is 2 seconds by default.
Command Mode: Global Mode.
Usage Guide: When the messages are being sent continuously, a sending delay is set to
prevent the Remote information from being updated repeatedly due to sending messages
simultaneously.
Example: Set the delay of sending messages as 3 seconds.
Switch(config)# lldp transmit delay 3
To Next Page
Loading...
