96
command will restore the default interval for the hello messages.
Parameters: The interval for the Hello messages, with its value limited between 5 and
100 seconds, 10 seconds by default.
Command Mode: Global Configuration Mode.
Default: 10 seconds by default.
Usage Guide: Interval for hello messages can be configured only if ULDP is enabled
globally, its value limited between 5 and 100 seconds.
Example: To configure the interval of Hello messages to be 12 seconds.
Switch(config)# uldp hello-interval 12
6.4 uldp aggressive-mode
Command: uldp aggressive-mode
no uldp aggressive-mode
Function: To configure ULDP to work in aggressive mode. The no form of this command
will restore the normal mode.
Parameters: None.
Command Mode: Global Configuration Mode and Port Configuration Mode.
Default: Normal mode.
Usage Guide: The ULDP working mode can be configured only if it is enabled globally.
When ULDP aggressive mode is enabled globally, all the existing fiber ports will work in
aggressive mode. For the copper ports and fiber ports which are available after the
configuration is available, aggressive mode should be enabled in port configuration mode.
Example: To enable ULDP aggressive mode globally.
Switch(config)# uldp aggressive-mode
6.5 uldp manual-shutdown
Command: uldp manual-shutdown
no uldp manual-shutdown
Function: To configure ULDP to work in manual shutdown mode. The no command will
restore the automatic mode.
Parameters: None.
Command Mode: Global Configuration Mode.
Default: Auto mode.
Usage Guide: This command can be issued only if ULDP has been enabled globally.
Example: To enable manual shutdown globally.
To Next Page
Loading...
