FoxGate S6124 - Ip Multicast Destination-Control Access-Group (Sip)

248
Parameter: <6000-7999>: destination-control access-list number.
Default: None
Command Mode: Interface Configuration Mode
Usage Guide: The command is only working under global multicast destination-control
enabled, after configuring the command, if IGMP-SPOOPING is enabled, for adding the
interface to multicast group, and match configured access-list, such as matching: permit,
the interface can be added, otherwise do not be added.
Example:
Switch(config)#inter e 1/4
Switch(Config-If-Ethernet 1/4)#ip multicast destination-control access-group 6000
Switch (Config-If-Ethernet1/4)#
24.1.4 ip multicast destination-control access-group
(sip)
Command: ip multicast destination-control <IPADDRESS/M> access-group
<6000-7999>
no ip multicast destination-control <IPADDRESS/M> access-group
<6000-7999>
Function: Configure multicast destination-control access-list used on specified net
segment, the ―no ip multicast destination-control <IPADDRESS/M> access-group
<6000-7999>― command deletes this configuration.
Parameter: <IPADDRESS/M>: IP address and mask length;
<6000-7999>: Destination control access-list number.
Default: None
Command Mode: Global Mode
Usage Guide: The command is only working under global multicast destination-control
enabled, after configuring the command, if IGMP-SPOOPING is enabled, for adding the
members to multicast group. If configuring multicast destination-control on specified net
segment of transmitted igmp-report, and match configured access-list, such as matching
permit, the interface can be added, otherwise do not be added. If relevant group or source
in show ip igmp groups detail has been established before executing the command, it
needs to execute clear ip igmp groups command to clear relevant groups in Admin mode.
Example:
Switch(config)#ip multicast destination-control 10.1.1.0/24 access-group 6000