User Guide
240
automatically receives the fax, and when the machine detects a phone call, the machine automatically makes
the answering machine record the phone call. When the answering machine is turned off, the machine
automatically changes the receive mode to [FAX Mode] after the ringtone sounds for a predefined time
length. If the phone communication in your country is serial, this mode is not supported.
[DRPD Mode]
Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive ring service must be installed
on your telephone line by the telephone company. After the telephone company has provided a separate
number for faxing with a distinctive ring pattern, configure the fax setup to monitor for that specific ring
pattern.
[Ring Tone Volume]
Select the volume level of the ringtone. This is effective when [Receive Mode] is set to [TEL/FAX Mode], and the
ringtone is heard from the internal speaker when the machine receives the phone call.
[Auto Answer Setup]
Specify the settings for automatic fax reception.
[FAX Mode]
Set the interval at which the machine goes into the fax receive mode after receiving an incoming call.
[TEL/FAX Mode]
Set the interval at which the machine goes into the fax receive mode after the external telephone receives an
incoming call.
[Ans/FAX Mode]
Set the interval at which the machine goes into the fax receive mode after the external answering machine
receives an incoming call.
[Junk Fax Filter]
Specify whether to reject faxes from fax numbers not registered in the address book of the machine.
[Forward Settings]
Specify whether to forward incoming faxes to a specified destination.
[Off]
Prints incoming faxes.
[Forward]
Forwards incoming faxes to a specified destination.
[Forwarding Number]
Enter a fax number for the destination to which incoming faxes are forwarded.
[Print and Forward]
Prints incoming faxes and also forwards them to a specified destination.
[Forwarding Number]
Enter a fax number for the destination to which incoming faxes are forwarded.
[Forward to Email]
*1,2,3
Forwards incoming faxes to a specified e-mail address.
[Print and Email]
*1,2,3
Prints incoming faxes and also forwards them to a specified e-mail address.
[Forward to Server]
*3,4
Forwards incoming faxes to a specified server address.
[Print & Fwd to Server]
*3,4
Prints incoming faxes and also forwards them to a specified server address.
*1
Depending on the e-mail server settings, the machine may not display a transfer error. Make sure that the fax is properly forwarded to the
specified forwarding destination as needed.
*2
Requires mail server settings. For details, see the CentreWare Internet Services Help.
To Next Page
Loading...
